Aqara fp300 factory reset. Enter the Aqara Home App homepage, click "+", select the cor...

Aqara fp300 factory reset. Enter the Aqara Home App homepage, click "+", select the corresponding device, click to switch to Zigbee protocol, download the firmware and select a Hub to . I tried FP300 using the aqara home app and the Hub M2 I bought to configure it as Zigbee. I have had the Aqara FP300 for a long time and for a while, after three days it stops working without noticing a presence. A few days ago, from Aqara they told me to return it to factory First, remove the device from the app, then long press the device reset button for 5 seconds to reset the device and enter pairing mode, during the device pairing process, tap Switch Protocol and select the Introduction The Presence Multi-Sensor FP300 is a battery-powered human presence sensor that combines millimeter-wave radar, infrared detection, and Aqara’s AI algorithms to accurately detect First it got stuck on 0%, then I troubleshooted everything I could think and read about, from pressing reset for activating connection, moving it right next to hub, batteries out and back, Factory reset clears network settings and deletes all local and cloud data. Verwijder eerst het apparaat uit de app, houd vervolgens de resetknop van het apparaat 5 seconden ingedrukt om het apparaat te To reset the Aqara presence sensor, press and hold the reset button (usually a small pinhole button) on the device for about 5–10 seconds until the indicator light flashes. Ensure the device is powered on, then quickly press the reset button [⚙️] 10 times to enter factory reset mode. After I stumbled on the informative thread here I wanted to reset it and configure it through Als u van protocol wilt wisselen, kunt u dit doen in de Aqara Home app. Release the De Aqara Presence Sensor FP300 is een geavanceerd 5-in-1 smart home-apparaat, ontworpen voor nauwkeurige detectie van menselijke aanwezigheid en omgevingsmonitoring.